![]() Sheet provided with the new ID sensor unit/board.įor example, input "0.98" with SP3362-013 & 016.ģ. Input all correction coefficients for the ID sensor with the SP modes referring to the barcode Spacers should be used when a new ID sensor board is installed.Ģ. If the black spacers are stuck to the sensor board, remove all black spacers. If the value of SP3324-003 is still NOT “0” replace the ID sensor. ![]() If the value of SP3324-003 is still NOT “0” after repeating Steps 2 and 3, check the spring for the PTR unitĦ. ![]() If the value of SP3324-003 (Vsg error counter) is NOT “0”, repeat Steps 2 and 3.ĥ. Execute SP3011-001 (manual process control).Ĥ. NOTE: Never use alcohol, because this may damage the board.ģ. If the error persists after replacing the unit, contact your service representative. Remove the ITB and check if there is any printed lines on it - that is a good start. If the SC Code is not listed in this table, contact your service representative. If the SC code that is displayed on the control panel is listed in this table, carry out the recommended procedure. Clean the ID sensor with a cloth moistened with water. This table contains a list of selected SC codes. Download (File Size : 513 B) Ver.1. Download (File Size : 21,009 KB) Ver.1.48 Released Date: History Firmware. Please follow the troubleshooting steps below to resolve an SC400 (ID Sensor Adjustment Error).Ģ. Ricoh SAP Device Types for Barcode & OCR Package. The following is from TSB 45 for this model: RICOH MPC2551 ID SENSOR BOARD MANUAL RICOH MPC2551 ID SENSOR BOARD CODE US 42. ![]() How can we fix the error code sc400 Check the ID sensor: open the side cover and remove the ITB unit. Some Possible causes: Presence of dust or dirt on the ID sensor. There may be some causes behind this error. If this error code displays on your machine, then you can't continue your work until you fix it. Use only a clean cloth moistened with water only. The error code sc400 in Ricoh Aficio MPC 2051 multifunction printer indicates the ID sensor adjustment error. Clean the ID sensors with clean cloth moistened by alcohol.Do not use alcohol as it can etch the surface of the sensor and then you will have to replace the sensor.
0 Comments
Leave a Reply. |